SEALQUIK is the first oil-based pigmented sealer that cleans up in water made in NZ. -Dries in about 30 minutes and can be re-coated in 1 Hour -Can be used over all types of paper faced wallboard, MDF & Plaster -Can be used under and over wallpaper. SealQuik has the advantages of drying quickly like a wallboard acrylic sealer but with the increased adhesion and better sand qualities of a traditional oil-based pigmented sealer. Features: excellent adhesion, good hiding powers, self leveling and quick drying and fast re-coat time. Can be used on:(interior surfaces) new walls and ceilings and the following substrates paper faced wallboard, interior concrete, solid plaster, customwood (MDF) or particle board and pre-painted areas. Can be over coated with: water-based or oil-based coatings Surface Preparation: The surface must be clean, Free of loose paint, grease and dust. Any surface with signs of Mould needs to be treated with a mould and mildew solution Not recommended for exterior use. Plaster, Paper faced wallboard, MDF New plaster will need to be cured prior to painting. Once prepared all surfaces must be sound and free from dust or loose material. Wall coverings For under wallpaper SealQuik must be fully cured (Normally 4-6 days) for over wallpaper check paper is sound prior to applying & we recommend testing before using. Prior to application: Mix the contents in the can thoroughly before and during use to ensure the coating remains consistent. Apply in full even coats. Do not thin . Directions: Can be applied by: Brush, Roller, pad or Sprayer
Winter conditions: please read -in low temperatures or high humidity extra precautions must be taken. While SealQuik has a very dry time, it still requires 4-6 days curing if either wallpapering or plastering may be done, as is the case with all standard pigmented sealers. The aid of heaters and dehumidifiers will assist in this process.
Coverage: 9-14 Sq metres per Litre (per coat) depending on porosity & texture of surface.
Dry time: 30 minutes
Re-Coat: 1-2 hours (depends on humidity & temperature)
Thinning: Not recommended
Clean-up: Warm soapy water
Storage & surface temperature: Do not store or apply if lower than 10ºC or above 35 ºC